18
Installation of Complete WaterSwitch System
Pump Cover Kit installation
1. Place Pump/Cover assembly in position required for installation and remove cover,
2. Install all necessary pipework for Mains, House/Garden and Tank supply.
3. Please flush clean pipe work to waterswitch before connection.
4. Connect tank water, mains and house/garden supply pipework as shown,
- ensure the fibre washers of the flat seat nut connections are in place.
5. Turn on mains water and power - Please refer to Commissioning notes pg 13
Owner’s Manual for further detail
6. Cut out end slots, each end of cover, to suit fl exible hose.
7. Replace pump cover and attach with 4 screws supplied.
To Next Page
Loading...
