What to do if all Pentair COLOR SYNC lights are not turning on?
If all lights are not turning on, replace any faulty light(s). If the issue continues, make sure the correct transformer (XFRMR) output 12/13/14 VAC is selected for the load and cable lengths. If the problem still persists, then replace the Pentair Controller.
How to fix Pentair Controller lights that turn on but do not stay synchronized?
To resynchronize the lights, reset them by holding the Pentair Controller button until it resets. Try again to see if the lights remain synchronized. If they do not, the Controller should be replaced.
Why won't my Pentair COLOR SYNC Controller lights turn on and the Color Sync LEDs are flashing?
If your Pentair Controller detects an electrical load exceeding the maximum allowable wattage or temperature, all Color Sync LEDs might flash, and the lights won't turn on. To resolve this, reduce the light load (wattage) on the controller and/or replace any damaged electrical components. Then, turn the controller off at the circuit breaker and back on to reset it and resume normal operation.
Core safety instructions for installation and use.
Critical warnings about electrical shock hazards.
Specific cautions for control installation location.
Industry Canada compliance notice.
RF exposure guidelines for device installation.
Key technical specifications and capabilities.
Requirements for the required outlet box.
General| Brand | Pentair |
|---|---|
| Model | COLOR SYNC CONTROLLER |
| Category | Controller |
| Language | English |
To Next Page