Need help?Do you have a question about the Pentair INTELLIVALVE and is the answer not in the manual?
General| Voltage | 24V AC |
|---|---|
| Valve Type | Diverter Valve |
| Communication | Wired |
| Operating Temperature | 32°F to 122°F (0°C to 50°C) |
| Features | Programmable |
| Type | Automatic Valve Actuator |
| Compatibility | IntelliCenter, EasyTouch, ScreenLogic |
Describes how to install the IntelliValve Valve Actuator on 2-way, 3-way, or 3-way Y valve assemblies.
Aligns the actuator shaft over the valve shaft and secures it with mounting screws.
Explains the functions of the MODE button and its different operational modes.
Details the default diverter end points and the 'Home' position setting.
Step-by-step guide to set diverter travel end points using arrow buttons.
Manual control mode for pool maintenance or service purposes.
Explains how to reverse the diverter's Home position between end points.
Demonstrates setting end points for partial water flow to spa/spillway.
Illustrates IntelliValve LED positions relative to 3-way valve diverter seal positions.
Illustrates IntelliValve LED positions relative to 2-way valve diverter seal.
Illustrates IntelliValve LED positions relative to 3-Way Y valve diverter seal.
Details connecting the IntelliValve to the EasyTouch control system circuit board.
Details connecting the IntelliValve to the IntelliTouch control system circuit board.
Addresses issues where the actuator fails to move or reverts to a previous position.
Troubleshoots a stuck actuator with blinking LEDs and an illuminated Service LED.
Checks if the IntelliValve actuator is in AUTO mode when the valve is not rotating.
To Next Page