How to fix Pentair AK110 if pH not reading correctly?
To address incorrect pH readings on your Pentair Controller, begin by using a test strip to verify the pH level. Then, check that the BNC sensor wires are correctly installed and if necessary, install a new BNC sensor wire. Verify the sensor's manufacture date and confirm that the flow rate in the AK1200 Flow Cell is between 0.5 and 1.5 liters per minute.
What to do if Pentair AK110 shows high pH alarm?
If the high pH alarm is on for your Pentair Controller, increase the ON time (CO2) to allow for a slower reaction, providing more time ON. Also, verify that the chemical tank is not empty.
Why are relays 1 and 2 not turning on automatically on my Pentair Controller?
If Relays 1 & 2 on your Pentair Controller are not turning ON automatically but work manually, ensure the flow switch is closed and verify that the green flow light is on. You should also check the set points.
What to do if Pentair AK110 displays overfeed alarm?
If the overfeed alarm is on for your Pentair Controller, increase the overfeed time. Also, ensure that the feeder is functioning correctly.
What to do if the magnet will not go up on Pentair AK110 Controller?
If the magnet on your Pentair Controller will not go up, clean the filter on the flow cell. Also, back wash the main filter or increase the flow.
General| Model | AK110 |
|---|---|
| Category | Controller |
| Number of Valves | 1 |
| Timer | Yes |
| Backwash Cycle | Yes |
| Rinse Cycle | Yes |
Details risks and precautions related to electrical shock during installation and operation.
Provides general safety advice and precautions for handling chemicals and using the controller.
Covers initial inspection, shipping verification, and the overall installation steps.
Provides recommendations for selecting a suitable location and securely mounting the controller unit.
Details electrical ratings, voltage selection, and power connection procedures.
Explains electrical load capacities and types of available relay modules.
Covers placement of feed pumps and installation procedures for heaters.
Provides instructions and principles for connecting the flow cell and water lines.
Lists parts of the AK1200 flow cell and guides assembly, mounting, and line installation.
Details flow cell mounting and the installation of inlet and exit lines.
Details pH, ORP, AKColor PPM, temperature, and flow sensors, including installation.
Provides instructions for sensor cleaning and performing final system installation tests.
Covers the initial power-up sequence, self-test, and module detection.
Describes the display screen and the process for calibrating temperature and pH.
Details the procedures for calibrating ORP and calculated PPM values.
Details Security and Wizards setup options within the configuration menu.
Instructions for configuring email addresses and implementing system security.
Provides a table of common issues and their recommended solutions for quick reference.
Details ORP calibration actions and the procedure for using a test strip.
Offers solutions for problems related to AKColor PPM and pH readings.
Guides the user through programming the pH Mix Time settings.
Continues the pH Mix Time programming guide, covering setpoints and feed logic.
Details programming steps for pH Cycle Time control, including manual feed time and cycle time.
Completes the pH Cycle Time programming guide, covering setpoints and feed logic.
Guides programming for ORP Mix Time, focusing on manual feed time and setpoints.
Continues ORP Mix Time programming, covering feed logic and timers.
Completes ORP Mix Time programming, covering overfeed and minimum off-time settings.
Details programming for ORP Cycle Time, including manual feed time and pH setpoints.
Continues ORP Cycle Time programming, covering feed logic and setpoints.
To Next Page