5
ACU-TROL
®
AK110 Chemical Controller Installation and User's Guide
Most states and local codes regulate the construction, installation, and operation of
public pools and spas, and the construction of residential pools and spas. It is important
to comply with these codes, many of which directly regulate the installation and use
of this product. Consult your local building and health codes for more information.
SERIOUS BODILY INJURY OR DEATH CAN RESULT IF THIS PRODUCT IS NOT INSTALLED
AND USED CORRECTLY.
INSTALLERS, POOL OPERATORS AND POOL OWNERS MUST READ THESE WARNINGS AND
ALL INSTRUCTIONS BEFORE USING THIS PRODUCT.
IMPORTANT NOTICE - Attention Installer: This Installation and User’s Guide
(“Guide”) contains important information about the installation, operation and safe use
of this product. This Guide should be given to the owner and/or operator of this product.
DO NOT INSTALL THE AK110 CHEMICAL CONTROLLER WHERE IT CAN BE READILY
ACCESSIBLE TO THE PUBLIC.
Before installing this product, read and follow all warning notices and instructions in this
Guide. Failure to follow warnings and instructions can result in severe injury, death, or
property damage. Call (800) 831-7133 for additional free copies of these instructions.
BEFORE WORKING ON THE AK110 CHEMICAL CONTROLLER: Always disconnect power to the
AK110 controller at the circuit breaker before servicing. Failure to do so could
result in death or serious injury to service person, pool users or others due to electric
shock.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION:
This product must be installed by a licensed or certified electrician or a qualified pool professional in accordance
with the National Electrical Code (NEC), NFPA 70 or the Canadian Electrical Code (CEC), CSA C22.2. All
applicable local installation codes and ordinances must also be adhered to. Improper installation will create an
electrical hazard which could result in death or serious injury to pool users, installers or others due to electrical
shock, and may also cause damage to property.
Do not permit children to operate this equipment.
When mixing acid with water, ALWAYS ADD ACID TO WATER. NEVER ADD WATER TO ACID.
When adding any chemical to the pool/spa, be sure to follow the manufacturer’s instructions
thoroughly.
DO NOT MIX SODIUM HYPOCHLORITE AND MURATIC ACID
Risk of electrical shock. Connect AK110 Chemical Controller to a ground-fault interrupter-circuit
(GFCI). Contact a qualified electrician if you cannot verify that the receptacle is protected by a
GFCI.
BE SURE TO DISCONNECT ALL SUPPLY CONNECTIONS BEFORE SERVICING.
BEFORE USING YOUR POOL, SPA OR HOT TUB, CHECK THE
pH AND SANITIZER LEVELS OF THE WATER
.
IF “CLEAR OVERFEED LIMIT” SETTING IS SET TO 24 HOURS, DO NOT SET “FEED TIME”
GREATER THAN 20 HOURS AS THIS WILL VOID NSF CERTIFICATION.
IMPORTANT WARNING AND SAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
