Pentair AK110 - AK110 SECURITY SETUP SCREEN NAVIGATION; MASTER AND SERVICE PASSWORD SETUP

124
pH > 7.67-OFF 7.50s
ORP 490 -OFF 700s _____ 69.0f SW1OFFSW2OFF
Main Status Screen
Name:Main Pool System Programming
Service Data ( 8:441 ) Communications >Security Setup Wizards Serial # 123456
Configuration Menu, Security Setup
AK110 Security Setup Screen Navigation
Enter New Password Screen
EnterBack
-Password Setup- >Master: 0 Service:0 Clear All Passwords
Security Setup, Master Password
Enter Password Current: 0 0 v-Cancel ^
Enter New Password Screen
-Password Setup- Master: 8675309 >
Service:0
Clear All Passwords
Security Setup, Service Password
-Confirm Changes - Clear ALL passwords? NO:7 9:YES
Clear All Passwords Screen
Press the [9] key to clear the master and service security passwords or the [7] key to cancel.
-Password Setup- Master: 8675309 Service:1776 >
Clear All Passwords
Security Setup, Clear All Passwords
Enter
9 7 or
Enter Enter
Enter Password Current: 0 0 v-Cancel ^
Use the keypad to enter the master password, up to 9 digits in length. Press the [Enter] key to confirm or the down arrow key to cancel. Use the keypad to enter the service password, up to 9 digits in length. Press the [Enter] key to confirm or the down arrow key to cancel.
Up to two levels of security may be implemented on the AK110 controller. The Master password enables access to
all controller functions and menus. A master password may be implemented alone, or in conjuntion with a service password. The more limited Service password allows access to sensor calibration screens from the Main Status Screen. A service password may be implemented only after a master password has been implemented. The password chosen by the user is simply a number, consisting of a minimum of one digit and a maximum of nine digits. There are, however, a few restrictions when choosing a password: 1. The password may not begin with a zero [0] as the first digit. 2. The security password must be in the range of "1" to "999999999", with the exception of two reserved number ranges. 3. The numbers in the ranges of 9000 to 9100 and 9276100 to 9276110 are reserved and cannot be used for security password purposes. Both passwords may be cleared simultaneously, by selecting the Clear All Passwords option on the Security Setup Screen. This effectively turns off the AK110 security feature. Alternatively, entering a passoword of "0" will disable the password feature. In order for the passwords to be cleared, the user must have first entered in a master password to gain access to the Security Setup Screen.
pH > 7.67-OFF 7.50s ORP 490 -OFF 700s _____ 69.0f SW1OFFSW2OFF
Main Status, cursor at pH value
Enter new value Current: 7.67 7.67 v-Cancel ^
Calibration Screen, pH
Enter Password Enter: v-Cancel
Password Prompt Screen
Enter Password Enter: **** v-Cancel
Password Displayed as Asterisks
Enter
Use Keypad to
Enter Password
>Name:Main Pool System Programming
Service Data ( 8:441 ) Communications Security Setup Wizards Serial # 123456 pH > 7.67-OFF 7.50s ORP 490 -OFF 700s _____ 69.0f SW1OFFSW2OFF
Main Status Screen Configuration Menu Screen
Enter Password Enter: v-Cancel
Password Prompt Screen
Enter Password Enter: ******** v-Cancel
Password Displayed as Asterisks
Enter
Use Keypad to
Enter Password
Using the AK110 Security Password Feature
Service Password ExampleMaster Password Example
Back
Back Enter
AK110 Security Setup Screen Navigation, Rev 3 21 Aug 2008
10.27