Pentair AK110 - Wizards

38
ACU-TROL
®
AK110 Chemical Controller Installation and User's Guide
When leaving an editing screen you will need to confirm the changes by pressing “9” or cancel by pressing press "7".
Also after making any changes be sure to press the "Back" button until you reach the main menu screen. Otherwise your
changes will not be saved.
The following list shows all the "Wizards" available with the Controller:
Control options for pH Relay 1
 1. pH,MixTime–usetocontrolapHfeedsystem.
 2. pH,CycleTime–usetocontrolapHfeedsystem.
 3. NotUsed–usetodisablethisrelay
Control options for ORP/PPM Relay 2
 1. ORP/PPM,MixTime–usetocontrolasanitizerfeedsystem.
 2. ORP/PPM,CycleTime–usetocontrolasanitizerfeedsystem.
3. ORP, Cal Hypo - use to control Cal Hypo feed system
4. Not Used - select to disable this relay.
 5. PPM,Mixtime-usethecalculatedPPMfeatures
6. PPM, Cycle time, use the calculated PPM features
Control options for Relay 3
1. Not Used - select to disable this relay.
2. Probe Clean - use to introduce acid for a short time to clean sensors.
 3. Heater-Usedtocontroltemperaturewithanexternalheater.
 4. AlarmOut-externalalarmcontrol.
 5. pH,MixTime-usedforadditionalpHcontrol(i.e.whenbothAcidandBaseareneeded.
6. pH, Cycle Time - optional method see program.
7. AUX: Make UP - control a make-up water system (auto fill).
8. Daily - turns on relay once per day
9. Weekly - turns on relay once per day on selected day(s) of the week.
 10. ORP/PPMMixTime-useforadditionalsanitizercontrol
(i.e. when a liquid feed system is used to back up a salt generator).
11. ORP/PPM, Cycle Time - optional method see program.
Control options for Pager/Email 1-4
1. Pager 1-4/Email 1-4
2. Not Used
See page 110 for the AK110 Wizards Setup Screen Navigation
Wizards