Pentair AK110 - Configuration Menu

31
ACU-TROL
®
AK110 Chemical Controller Installation and User's Guide
The Configuration Menu consists of the following:
• Name:Setsupthenameofyouraquaticsystemforeasy
identification during communication and on the wireless
data management system. See pages 56 for Controller
Name Navigation Menu Tree.
• System:Setsuptime,date,weekday,andunitdisplay 
(English or Metric). See pages 58 or System Set-up Screen
Navigation.
• Programming:RelayprogrammingforRelays1,2,3,Alarm,andPagers.SeeProgramming 
Section for details. See pages 52-109 for Programming Set-up Menus.
• Service:Clearcalibrations,data,orrelaytimersaspartofnormalserviceoperations.
• Data:Sensorreadingsarerecordedatadefault2hoursintodata.Atotalof441linesofdatacanbe
stored. Press the down arrow key to view data. See page 114 for Data Screen Navigation.
• Communications:Setupmodems,pagernumbersandoremailaddresses.Seepages102-105for
Programming Screen Navigation Pager 1. See page 116 for Communications Screen for Dail-up and
Internet Modems. See pages 106 for Programming Screen Navigation Email.
• SecuritySetup:Setsuppasswords,clearspasswords,andresetsallsettingstofactorydefaults.
See pages 126 for Security Setup Screen Naviagtions.
• Wizards:Selectpre-writtenprogramsforcommonControllerapplications.
See pages 110 for Wizards Setup Screen Navigation.
• Serial#:Viewtheserialnumberhere.Theserialnumberisrequiredwhenrequestingsupport.
Note:
When entering pulses per gallon the Controller will only
update this measurement once every 10 seconds.
Conguration Menu
To clear the Total, for any switch place the cursor on Clear
and press ENTER.
Conguration Menu Screen
>Name:Main Pool
System
Programming
Service
Data ( 8:441 )
Communications
Security Setup
Wizards
Serial # 123456
Flow Switch 2 Setup, Clear Counter
Flow Switch #2
SW2 K => 8.5 pul/g
g/m = 35
Total = 0 >Clear