82
pH > 7.67-OFF 7.50s
ORP 490 -OFF 700s
ProbeClean-OFF
69.0f SW1OFFSW2OFF
Main Status Screen
Name:Main Pool
System
>Programming
Service
Data ( 8:441 )
Communications
Security Setup
Wizards
Serial # 123456
Configuration Menu, Programming
AK110 Programming Screen Navigation, Probe Clean
EnterBack
1:pH, Mix Time
2:ORP, Mix Time
>3:ProbeClean
A:Alarm
P:Pager1
P:Pager2
P:Pager3
P:Pager4
Programming Setup Screen
Probe Clean, Manual Cycle Time
EnterBack
Enter new value
Current: 00:02:00
00:02:00
v-Cancel ^
Manual Cycle Time Screen
Use the keypad to enter the manual
probe cleaning cycle duration.
Press the [Enter] key to confirm or
the down arrow key to cancel.
Enter
Enter new value
Current: 00:00:02
00:00:02
v-Cancel ^
Probe Clean, Independent of SW1
Press the [Enter] key to make the
probe cleaning cycle dependent or
independent of the status of the flow
switch SW1.
Note:
The relay 3 programming menu
appears in this format only when
relay 3 has been configured for
"ProbeClean" control.
ManualTime 00:02:00<
On IfTime> 00:00:02
OffIfTime> 00:00:20
Off if Sw1 Off-YES
Probe Clean, Probe Clean Start Time
ManualTime 00:02:00
On IfTime> 00:00:02<
OffIfTime> 00:00:20
Off if Sw1 Off-YES
Enter
Probe Clean, Probe Clean Stop Time
ManualTime 00:02:00
On IfTime> 00:00:02
OffIfTime> 00:00:20<
Off if Sw1 Off-YES
Probe Clean, Off if SW1 is Off
ManualTime 00:02:00
On IfTime> 00:00:02
OffIfTime> 00:00:20
Off if Sw1 Off-YES <
ManualTime 00:02:00
n IfTime> 00:00:02
OffIfTime> 00:00:20
Off if Sw1 Off-NO <
Enter new value
Current: 00:00:20
00:00:20
v-Cancel ^
Use the keypad to enter the time to
end the probe cleaning cycle.
Press the [Enter] key to confirm or
the down arrow key to cancel.
Use the keypad to enter the time to
begin the probe cleaning cycle.
Press the [Enter] key to confirm or
the down arrow key to cancel.
Probe Clean Stop Time Screen
Probe Clean Start Time Screen
Back
AK110 Programming Screen Navigation, Probe Clean, Rev 3 22 Aug 2008
10.13
To Next Page
Loading...
