Pentair AK110 - EMAIL SETUP AND SECURITY IMPLEMENTATION

37
ACU-TROL
®
AK110 Chemical Controller Installation and User's Guide
Email Set-up
Email addresses:
The programming setup screen will display up to four email addresses. This will allow the system to email up to four
addresses to alert more than one technician when a pool problem arises. The process to enter email address in the
AK110 is as follows:
1. Press BACK button to reach MAIN Screen.
2. Scroll down to Communications
3. Press ENTER to select Communications
4. Scroll down to Email addresses and press ENTER to select Email addresses
5. Select the #1 email address location.
 6.Usingthekeypadtoenteremailaddress.Usingcursorarrowstomovetothenextletterandsoon.(Thekey
padworksexactlylikeacellphonekeypadandenteringinformationasyouwouldaphonenumberinyourcellphone
addressbook).Ifyouremailaddressistolongforthespacesavailableusethenextavailableemailaddresstocom-
pletetheaddress.Add"+02"totheendoftheaddresswhereyouneedtobreaktothenextline.
Example:email1:johndoe@+02
email 2: myserver.com
See page 106 for more detailed email set-up process.
Security
Up to two levels of security may be implemented on the AK110 Controller.
1. Master Password: The master password enables access to all controller functions and menus. A master password
maybeimplementedaloneorinconjuntionwithaservicepassword.
2. Service Password: The more limited Service password allows access to sensor calibrations screens from the
Main Status Screen. A service password may be implemented only after a master password has been implemented.
Passwords consist of up to nine digits.
Password restrictions:
1. The password may not be begin with a zero (0) as the first digit.
2. The security password must be in the range of "1" and "8999" and "9011 and "999999999".
The numbers 9000-9010 are reserved for technical support purposes and may not be used.
3. A master password is required for should a wireless modem be installed in the AK110.
See page 126 for the AK110 Security Set-up Screen Navigation for more detailed security set-up process.