Pentair AK110 - PROGRAMMING SCREEN NAVIGATION: PPM MIX TIME (2 of 2)

79
pH > 7.67-OFF 7.50s
ORP 490 -OFF 700s PPM, Mix T-OFF 69.0f SW1OFFSW2OFF
Main Status Screen
Name:Main Pool System >Programming
Service Data ( 8:441 ) Communications Security Setup Wizards Serial # 123456
Configuration Menu, Programming
AK110 Programming Screen Navigation, PPM Mix Time (1 of 2)
EnterBack
1:pH, Mix Time
2:ORP, Mix Time
>3:PPM, Mix Time
A:Alarm P:Pager1 P:Pager2 P:Pager3 P:Pager4
Programming Setup Screen PPM Mix, Manual Feed Time
EnterBack
PPM Mix, Proportional Feed Percent PPM Mix, Low PPM Setpoint
PPM Mix, Feed Off if Relay is On
Enter new value Current: 00:02:00 00:02:00 v-Cancel ^
Manual Feed Time Screen Use the keypad to enter the manual sanitizer feed duration. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter
Proportional Feed Percent Screen Use the keypad to enter the proportional feed percentage. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter
Enter new value Current: 10 10 v-Cancel ^ Enter new value Current: 2.00 2.00 v-Cancel ^
Use the keypad to enter the low PPM value under which the sanitizer will feed. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter
Low PPM Setpoint Screen
Use the keypad to enter the number of a pH feed control relay to prevent simultaneous chemical feed. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter
Feed Off if Relay is On Screen
Enter new value Current: 1 1 v-Cancel ^
Use the keypad to enter the time delay between the setpoint trigger and the chemical feed cycle start. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter
Delay Time Screen
Enter new value Current: 00:00:20 00:00:20 v-Cancel ^
Enter Enter
PPM Mix, High pH Setpoint PPM Mix, Low pH Setpoint
PPM Mix, Delay Time
Enter new value Current: 7.95 7.95 v-Cancel ^
Use the keypad to enter the high pH value over which the sanitizer will not feed. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter new value Current: 0.00 0.00 v-Cancel ^
High pH Setpoint Screen Low pH Setpoint Screen Use the keypad to enter the low pH value under which the sanitizer will not feed. Press the [Enter] key to confirm or the down arrow key to cancel.
Note: The relay 3 programming menu appears in this format only when relay 3 has been configured for "PPM Mix Time" control.
To PPM Mix Time (2 of 2)
ManualTime 00:02:00<
Proportional% 10 On If PPM< 2.00 Off If PPM> 0.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
ManualTime 00:02:00 Proportional% 10< On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00 ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00< Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95< Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00 ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00< Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1< On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00 ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20< On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
Back
AK110 Programming Screen Navigation, PPM Mix Time, Rev 3 22 Aug 2008