Pentair AK110 - PROGRAMMING SCREEN NAVIGATION: ORP MIX TIME (3 of 2)

64
AK110 Programming Screen Navigation, ORP Mix Time (2 of 2)
ORP Mix, Feed Off if SW1 is Off ORP Mix, Independent of SW2
Enter Enter
Setpoint Overfeed Screen Use the keypad to enter the daily maximum accumulated feed time. Press the [Enter] key to confirm or the down arrow key to cancel. Overfeed Screen
Enter new value Current: 03:00:00 03:00:00 v-Cancel ^
Enter Enter
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES < Off if Sw2 On –NO SetOvrfeed 00:00:00 Overfeed 03:00:00 ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On –NO < SetOvrfeed 00:00:00 Overfeed 03:00:00
ORP Mix, Setpoint Overfeed
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00< Overfeed 03:00:00
ORP Mix, Overfeed
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00<
From ORP Mix Time (1 of 2)
ORP Mix, Independent of SW1
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-NO < Off if Sw2 On –NO SetOvrfeed 00:00:00 Overfeed 03:00:00
ORP Mix, Feed Off if SW2 is On
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On –YES < SetOvrfeed 00:00:00 Overfeed 03:00:00
Use the keypad to enter the runtime allowed to reach 5% of setpoint. Disables relay if setpoint is not met. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter new value Current: 00:00:00 00:00:00 v-Cancel ^
Press the [Enter] key to make the sanitizer feed dependent or independent of the status of switch 2 (SW2.) Press the [Enter] key to make the sanitizer feed dependent or independent of the status of the flow switch SW1.
Use the keypad to enter the maximum sanitizer feed duration. Press the [Enter] key to confirm or the down arrow key to cancel. On Time Screen
Enter new value Current: 00:01:00 00:01:00 v-Cancel ^
Enter
ORP Mix, On Time
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00< MinTimeOff 00:07:00 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
ORP Mix, Minimum Time Off
Enter
ManualTime 00:02:00 Proportional% 5 On If ORP< 700 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 On DELAY 00:00:20 On Time 00:01:00 MinTimeOff 00:07:00< Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00
Use the keypad to enter the amount of time the relay will be held off during a feed cycle to allow mixing. Press the [Enter] key to confirm or the down arrow key to cancel. Minimum Time Off Screen
Enter new value Current: 00:07:00 00:07:00 v-Cancel ^
AK110 Programming Screen Navigation, ORP Mix Time, Rev 3 22 Aug 2008