Pentair AK110 - PROGRAMMING SCREEN NAVIGATION: PPM CYCLE TIME (3 of 2)

76
AK110 Programming Screen Navigation, PPM Cycle Time (2 of 2)
Setpoint Overfeed Screen Use the keypad to enter the daily maximum accumulated feed time. Press the [Enter] key to confirm or the down arrow key to cancel. Overfeed Screen
Enter new value Current: 03:00:00 03:00:00 v-Cancel ^
Enter Enter
PPM Cycle, Setpoint Overfeed PPM Cycle, Overfeed
Use the keypad to enter the runtime allowed to reach 5% of setpoint. Disables relay if setpoint is not met. Press the [Enter] key to confirm or the down arrow key to cancel.
Enter new value Current: 00:00:00 00:00:00 v-Cancel ^
From PPM Cycle Time (1 of 2)
ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 Cycle Time 00:02:00 On Limit 00:00:30 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00< Overfeed 03:00:00 ManualTime 00:02:00 Proportional% 10 On If PPM< 2.00 Off If pH> 7.95 Off If pH< 0.00 Off if RLY On 1 Cycle Time 00:02:00 On Limit 00:00:30 Off if Sw1 Off-YES Off if Sw2 On -NO SetOvrfeed 00:00:00 Overfeed 03:00:00<
AK110 Programming Screen Navigation, PPM Cycle Time, Rev 3 22 Aug 2008