Pentair STA-RITE INTELLIFLO3 VSF User Manual

4
INTELLIFLO3™ VSF and INTELLIPRO3™ VSF Variable Speed and Flow Pump User's Guide
PumpDashboard
The Pump Dashboard is your pump's home page. Basic pump info, run status and programming can be viewed from
this screen.
If any pump alerts and problems are present they will also display at the top of this screen.
1− DeviceSettings: Tap to display the Device
Settings screen.
Most of the pump features and settings can be
accessed from the Device Settings screen. Refer
to Device Settings, page 6.
2− Enabled/DisabledToggle: Tap to enable or
disable your pump.
A DISABLED pump will not start until this toggle
is switched to ENABLED or the pump ON/STOP
button is pressed.
3− CurrentStatus:Displays the current pump state.
IDLE: The pump is not currently running a
program.
PROGRAM: Displays the program currently
running.
4− NextProgram:Displays the next program
scheduled to run after completion of the current
program or idle.
If all programs are programmed manual or timer
"No Programs are Scheduled" will display.
5− RunData:Displays estimates of the pump's
current ow, power consumption and overall
system pressure.
6− ProgramTabs: Displays all pump Programs and
their individual settings.
Tap a Program Tab to edit or start a program.
Refer to Program Setup, page 5 for
programming instructions.
Note: Quick Clean will always display as a
program tab and cannot be removed from the
Pump Dashboard. Quick Clean is programmed
similarly to a Timer program.
7− Edit/RunProgramTabs: Displays when a
Program Tab is pressed.
EDIT: Tap to open the Program Setup screen.
Refer to Program Setup, page 5.
 RUNNOW/STOP:Tap to manually start or stop
a pump program.
FIGURE 6
2
3
1
5
6
4
7
OPERATION

Pentair STA-RITE INTELLIFLO3 VSF Specifications

General

Brand	Pentair
Model	STA-RITE INTELLIFLO3 VSF
Category	Water Pump
Language	English