6
Satellite led (green)
It shows the amount of locked satellites; when the receiver links one or more satellites signal it will
start to blink every 30 seconds for a number of times equal to the number of locked satellites.
When the receiver doesn’t lock satellites, the satellite led does not shine.
Figure 2- 2 Satellite led
Network led (green)
This light is on when GSM/GPRS module is selected as RTK datalink. It starts to blink when there is
data transfer ongoing (In both radio, Bluetooth and network data link mode, it will blink when
there is data transfer ongoing).
Figure 2- 3 Network led
Power led (green and red)
When you power on the G7H+, the power led will be on. According to the remaining power of the
battery, it includes two kinds of status:
1. Green: power supply in good condition.
2. Red: power is less than 10% (when the total power of two batteries is less than 10%, the power
led is red), and you will hear three beeps every 60s.
Figure 2-4 Power led
Note: Usually when the light is red you have still one hour of power reserve. External power and
internal battery share same power light. When external power is used, the led indicates the
external power level.
To Next Page
Loading...
