25
6.6.Settings
Settings includes settings for Working Mode, Device Configuration and NMEA Message.
6.7.Working Mode
In this page, you can set receiver working mode as required: Static mode, Rover mode and Base
mode. For each working mode, you can set datalink and other parameters as required.
① Static mode
In the Static mode settings, you can set cutoff angle, select satellite system, and input point name,
antenna height, PDOP threshold and interval.
Also, you can turn on/off the auto record. If the auto record is on, receiver would auto record data
when it’s switched on under static mode.
Figure 6-7
To Next Page
Loading...
