141
5
Function Reference
• Turn the e-dial while pressing the m c button and change the EV
Compensation value. (p.147)
• Set the shutter speed in increments of 1/2 EV or 1/3 EV. Set in [Expsr Setting
Steps] in the [A Custom Setting] menu. (p.148)
• You can automatically correct the sensitivity if appropriate exposure cannot
be set with the set criteria. Set [Sensitivity] to [AUTO] in the Fn menu. (p.121)
• Set the aperture to the s position while
holding down the auto-lock button when
using a lens with an aperture ring.
Exposure Warning
If the subject is too bright or too dark,
the aperture value will blink in the
viewfinder and on the LCD panel. If the
subject is too bright, choose a faster
shutter speed. If it is too dark, choose a slower shutter speed. When
the aperture value indication stops blinking, you can take the picture
with proper exposure.
If both the shutter speed and aperture value are blinking, this
indicates being out of metering range and the proper exposure
cannot be obtaind even if the shutter speed is adjusted.
Use an ND (Neutral Density) filter if the subject is too bright.
Use a flash if it is too dark.
To Next Page
Loading...
Need help?
General
