Pentax Optio W30 - Page 116

114
4
Taking Pictures
4 Set the interval.
1 Press the four-way controller (5).
2 Use the four-way controller (
23) to set
the interval, then press the four-way
controller (
4).
The frame returns to [Interval].
5 Press the four-way controller (3).
The frame moves to [Total Time].
6 Set the total time.
1 Press the four-way controller (5).
2 Use the four-way controller (
23) to set the hour, then press the
four-way controller (
5).
3 Use the four-way controller (
23) to set the minute, then press the
four-way controller (
5).
The frame returns to [Total Time].
7 Press the four-way controller (3).
The frame moves to [Start Delay].
8 Set the start delay.
1 Press the four-way controller (5).
2 Use the four-way controller (
23) to set the hour, then press the
four-way controller (
5).
3 Use the four-way controller (
23) to set the minute, then press the
four-way controller (
5).
The frame returns to [Start Delay].
9 Press the OK button.
The Interval movie setting is saved and the camera returns to capture
status.
10 Press the shutter release button halfway.
The focus frame on the LCD monitor turns green if the subject is in
focus.
11 Press the shutter release button fully.
Interval movie recording starts.
The camera turns off between shots (during standby). Press the power
switch during standby to display the remaining number of pictures and
interval on the LCD monitor.
Interval Shoot
MENU
Interval 1min
Total Time
Start Delay hr min00
hr min010