Pentax Optio W30 - Recording a Movie from Pictures Taken at a Set Interval (Interval Movie)

113
4
Taking Pictures
In this mode, you can record multiple still pictures taken automatically at
a set interval from a set time, as a movie file. The default frame rate for
the recorded movie is 30 fps (frames per second).
1 Press the four-way controller (2) in C mode.
2 Use the four-way controller (45)
to select k (Interval Shoot) and
press the 4 button.
The current Interval Movie setting appears
for approximately five seconds. To take
pictures with the current setting, go to Step 8.
3 Press the 4 button while the
setting is displayed.
The Interval Movie setting screen appears. [Interval] is marked with a
frame.
Recording a Movie From Pictures Taken at a Set
Interval (Interval Movie)
Interval
You can set this to 1 minute, 5 minutes, 10 minutes, 30 minutes, or
1 hour.
Total Time
Set the total time, from 10 minutes to 359 hours. The total time can
be set in increments of 1 minute, 5 minutes, 10 minutes, 30 minutes,
or 1 hour.
Start Delay
Set the start delay, from 0 minutes to 24 hours. The start delay can
be set in increments of 1 minute for a delay time up to 59 minutes,
and increments of 1 hour for a delay time longer than one hour. If the
start delay is set to 0 min., the first picture is taken as soon as the
shutter release button is pressed.
MENU
Rec.Mode
MENU
Exit
E x i t
Exit
1/3
7 M
Recorded Pixels
Quality Level
White Balance
AE Metering
Sensitivity
AWB
ISO
AUTO
10, 11
1, 2, 4, 5, 6, 7, 8
2, 3, 9
Drive Mode
D r i v e M o d e
Interval Shoot
I n t e r v a l S h o o t
OK
OK
O K
Drive Mode
Interval Shoot
OK