193
9
Appendix
Messages such as the following may appear on the LCD monitor when
using the PictBridge function.
Data being recorded
This message appears when you try to switch to Q mode
while an image is still being recorded, or when the protect
setting or DPOF setting is being changed. It disappears
after the image is recorded or the setting is changed.
Data being processed
This message appears when the camera takes more than
five seconds to display an image due to image processing,
or when the SD Memory Card or built-in memory is being
formatted.
Alarm is set
This message appears when the alarm is set and before the
camera automatically turns off.
Low paper level in the
printer
The paper level of the printer is low.
No paper in the printer There is no paper in the printer.
Paper stuck in the printer The paper is stuck in the printer.
Low ink level in the printer The ink level of the printer is low.
No ink in the printer There is no ink in the printer.
Printer error An error message has been sent from the printer.
Data error A data error message has been sent from the printer.
To Next Page
Loading...
