5
Press the shutter release button fully.
Countdown starts and the remaining seconds are displayed on the screen.
If you select
The self timer lamp and all of the macro lights turn on.
From 4 seconds before shooting, the macro lights turn off in order
from the top right.
From 3 seconds before shooting, the self timer lamp also blinks.
If you select d2_
The self timer lamp and the macro lights blink.
The picture is taken after a countdown of either ten seconds or two seconds.
Focusing may be compromised if you move the camera while the self-
timer lamp is blinking when taking still pictures.
• In ,_ (Movie) mode. recording will start after ten seconds (or two
seconds}.
• Press the shutter release button halfwaywhile the self-timer is engaged
to stop the countdown and press fully to restart the countdown
\3
• d2_cannot be selected while • (Green) mode is in default setting.
\3
Select _ nanother shooting mode and then switch the shooting mode
to •.
• The self-timer lamp does not flash in £b (Pet) mode.
• In the following situations, the macro lights remain turned on
regardless of tlqe countdown
In the Digital Microscope mode
- When [Macro Light] on the [1_1Rec. Mode] menu is set to _' (On)
Pictures are taken continuously as long as the shutter release button is
pressed.
Each time a picture is taken, the image is saved in the memory
DJj Continuous before the next image is taken. The higher the image quality,
Shooting the longer the interval between shots.
The number of recorded pixels is fixed at _ (2592x 1944)/
Burst _ (2592x1464) and the interval between shots is shorter
Shooting than "Continuous Shooting".
* The number of images that can be shot continuously and the interval between
shots depend on shooting situations.
To Next Page
Loading...
Need help?
General
