Pentax X-5 - Setting the Playback Shortcut; Resetting to Default Settings (Reset)

181
6
Settings
4 Use the four-way controller (23)
to select [Pixel Mapping].
5 Press the 4 button.
Defective pixels are mapped and corrected.
You can turn on the camera by holding down the Q button.
1 Use the four-way controller (23) to select [Playback
Shortcut] in the [W Setting] menu.
2 Use the four-way controller (45) to select O or P.
O Starts up in playback mode
P Does not start up in playback mode
3 Press the 4 button.
The setting is saved.
You can reset the camera settings to their defaults. Refer to “Default
Settings” (p.205) for the reset settings.
1 Use the four-way controller (23) to select [Reset] in
the [W Setting] menu.
2 Press the four-way controller (5).
The [Reset] screen appears.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] appears on the display. Use the AC adapter kit
K-AC129 (optional) or replace the batteries with those having sufficient
power.
Setting the Playback Shortcut
Resetting to Default Settings (Reset)
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel
OK
OK