Pentax X-5 - Selecting the Number of Recorded Pixels

90
3
Taking Pictures
The focus assist light aids in focusing on dark subjects. This helps you
to focus on the subject in low light conditions where auto focus does not
work properly. The focus assist light is emitted from the self-timer lamp
part.
3 Use the four-way controller (23) to select [Focus
Assist].
4 Use the four-way controller (45) to select O (On) or P
(Off).
The setting is saved.
Set the image tone of still pictures.
You can select from [Bright] (Default setting), [Natural] or [Monochrome].
1 Use the four-way controller (23) to select [Image
Tone] in the [A Rec. Mode] menu.
2 Press the four-way controller (5).
A pull-down menu appears.
3 Use the four-way controller (23) to select a finishing
tone.
4 Press the 4 button.
The setting is saved.
To Set the Focus Assist Light
• Looking at the light directly does not pose a safety but you may feel
dazzled. Do not look directly into the emitter from a very short distance.
• The camera does not emit the focus assist light under the following
conditions:
- when the capture mode is set to c (Time-Lapse Movie), C (Movie)
or d (High Speed Movie) mode
- when s (Infinity) or \ is selected as the focus mode
• The default setting in e (Pet) mode is P.
Setting the Image Tone