USER MANUAL
Peplink Balance Series
21 System Settings
21.1 Admin Security
There are two user accounts available for accessing the Web Admin.Usernames
are admin and user.They represent two user levels- admin has full administration access, while user is
a read-only account.The read-only account can only access the device's status information and cannot
make any change on the device.
A web login session will be logged out automatically when it has been idle longer than the Web Session
Timeout.Before the session expires, you may click the Logout button in the Web Admin to exit the
session
0 hours 0 minutes signifies an unlimited session time. This setting should be used only in
specialsituations, as it will lower the system security level if users do not logout before closing the browser.
Default: 4 hours 0 minutes.
For security reason, after logging in to the Web Admin Interface for the first time, it is recommended to
change the administrator password.
Configuring the administration interface to be accessible only from the LAN can further improve system
security.
Administrative Settings configuration is located at:System>Admin Security
Admin Account UI User Account UI
http://www.peplink.com -158 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
