USER MANUAL
Peplink Balance Series
21.4 Email Notification
The Email Notification functionality of Peplink Balance provides a System Administrator with up to date
information on network status.
The settings for configuring Email Notification are found at: System> Email Notification
Email Notification Settings
Email Notification
This setting specifies whether or not to enable Email Notification.
If the box Enable is checked, Peplink Balance sends email messages to a System
Administrator when the WAN status changes, or when new firmware is available.
If the box Enable is not checked, Email Noti
fication is disabled and Peplink Balance will not
send email messages.
SMTP Server
This setting specifies the SMTP server to be used for sending email. If the Server requires
authentication, check the box Require authentication.
SSL Encryption
Check the box to enable SMTPS. When the box is checked, the next field SMTP Port will
be changed to 465 automatically.
SMTP Port
This field is for specifying the SMTP Port number.
By default, this is set to 25; when the SSL Encryption box is checked, the default port
number will be set to 465.
You may customize the port number by editing this field. Click the button Default to restore
to default.
SMTP User Name /
Password
This setting specifies the SMTP username and password while sending email. These
options are shown only if Require authentication check box is checked in SMTP Server
setting.
Confirm SMTP
Password
This field allows you to verify and confirm the new administrator password.
Sender’s Email
Address
This setting specifies the sender email address reported by the email messages sent by
Peplink Balance.
Recipient’s Email
Address
This setting specifies the email address to which Peplink Balance should send the email
messages to.You may enter multiple recipients’ email addresses in this field.
http://www.peplink.com -164 / 207 - Copyright © 2013 Peplink
To Next Page
Loading...
