peplink Pepwave AP One Series

7.6 Captive Portal
The captive portal serves as a gateway that clients have to pass if they wish to access the
Internet using your router. To configure the captive portal, navigate to Network > Captive
Portal.
LAN Client(s)
NAT mapping rules can be defined for a single LAN IP Address, an IP Range, or an IP
Network.
Address
This is the IP address of the LAN host where the system will map the selected
connection IP addresses.
Inbound
Mappings
This section is to define which inbound IP addresses should be forwarded to the LAN
Client(s).
Outbound
Mappings
This section is to define which IP addresses of each WAN should be used when an IP
connection is made from the LAN host to the Internet.
https://www.peplink.com
34
Copyright @ 2020 Pepwave