peplink Pepwave AP One Series User Manual

Downstream Limit
Firewall Settings
Firewall Mode
Choose Flexible – Allow all except… or Lockdown – Block all except… to turn on
the firewall, then create rules for the firewall exceptions by clicking . See
the discussion below for details on creating a firewall rule. To delete a rule, click the
associated button. To turn off the firewall, select Disable.
Firewall Rule
Name
Enter a descriptive name for the firewall rule in this field.
Type
Choose Port, IP Network, MAC Address or Domain Name to allow or deny traffic from
any of those identifiers. Depending on the option chosen, the following fields will vary.
Port
Choose TCP or UDP from the Protocol drop-down menu to allow or deny traffic using
either of those protocols. From the Port drop-down menu, choose Any Port to allow or
deny TCP or UDP traffic on any port. Choose Single Port and then enter a port number
in the provided field to allow or block TCP or UDP traffic from that port only. You can
also choose Port Range and enter a range of ports in the provided fields to allow or
deny TCP or UDP traffic from the specified port range.
IP Network
If you have chosen IP Network as your firewall rule type, enter the IP address and
subnet mask identifying the subnet to allow or deny.
https://www.peplink.com
50
Copyright @ 2020 Pepwave

peplink Pepwave AP One Series Specifications

General

Brand	peplink
Model	Pepwave AP One Series
Category	Wireless Access Point
Language	English