15.2.4 Algorithm: Priority
This setting specifies the priority of the WAN connections used to route the specified network
service. The highest priority WAN connection available will always be used for routing the
specified type of traffic. A lower priority WAN connection will be used only when all higher
priority connections have become unavailable.
Starting from Firmware 5.2, outbound traffic can be prioritized to go through SpeedFusion
TM
connection(s). By default, VPN connections are not included in the priority list.
Configure multiple distribution rules to accommodate different kinds of services.
15.2.5 Algorithm: Overflow
The traffic matching this rule will be routed through the healthy WAN connection that has the
highest priority and is not in full load. When this connection gets saturated, new sessions will
be routed to the next healthy WAN connection that is not in full load.
Drag and drop to specify the order of WAN connections to be used for routing traffic. Only the
highest priority healthy connection that is not in full load will be used.
To Next Page
Loading...
