This setting specifies the SMTP username and password while sending email.
These options are shown only if Require authentication is checked in the SMTP
Server setting.
This field allows you to verify and confirm the new administrator password.
This setting specifies the email address the Pepwave router will use to send
reports.
This setting specifies the email address(es) to which the Pepwave router will send
email notifications. For multiple recipients, separate each email addresses using
the enter key.
After you have finished setting up email notifications, you can click the Test Email
Notification button to test the settings before saving. After Test Email Notification is clicked,
you will see this screen to confirm the settings:
Click Send Test Notification to confirm. In a few seconds, you will see a message with
detailed test results.
To Next Page
Loading...
