EasyManua.ls Logo

peplink Pepwave MAX BR1 MK2

peplink Pepwave MAX BR1 MK2
332 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
This radio transmitter 20682-P1AC4 has been approved by Innovation, Science and Economic
Development Canada to operate with the antenna types listed below, with the maximum
permissible gain indicated. Antenna types not included in this list that have a gain greater than
the maximum gain indicated for any type listed are strictly prohibited for use with this device.
WIFI Antenna type: Omni-directional
WIFI Antenna gain: 2.4GHz / 2.44 dBi , 5GH / 4.73 dBi
LTE Antenna type: Omni-directional
LTE Antenna gain: 4.38 dBi
Caution : ( for MAX BR1 MK2 )
(i) the device for operation in the band 5150-5250 MHz is only for indoor use to reduce the potential for
harmful interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the band 5725-5850 MHz shall be such that the
equipment still complies with the e.i.r.p. limits specified for point-to-point and non-point-to-point
operation as appropriate; and
(iii) Users should also be advised that high-power radars are allocated as primary users (i.e. priority
users) of the bands 5650-5850 MHz and that these radars could cause interference and/or damage to
LE-LAN devices.
Avertissement: ( for MAX BR1 MK2 )
(i) les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une
utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux;
(ii) le gain maximal d'antenne permis (pour les dispositifs utilisant la bande de 5725 à 5 850 MHz) doit
être conforme à la limite de la p.i.r.e. spécifiée pour l'exploitation point à point et l’exploitation non point
à point, selon le cas;
(iii) De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de haute
puissance sont désignés utilisateurs principaux (c.-à-d., qu’ils ont la priorité) pour les bandes
5650-5850 MHz et que ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs
LAN-EL.
CE Statement for Pepwave Routers ( MAX BR1 MK2 )
https://www.peplink.com
306
Copyright @ 2021 Pepwave

Table of Contents

Related product manuals