HART Multiplexer System KFD*-HM*-16
Configuration
2018-04
35
Installing Software Components
1. Install Microsoft
®
.NET Framework.
2. Install PACTwa re.
3. Install the HART multiplexer DTM.
4. Install the DTM HART Comm.
5. Install the field device-specific DTMs from the manufacturer of the field devices.
6. Install the DTM Generic HART if necessary.
Note!
The cross-device properties of the software are described in the manual "Installation and
Configuration Device Type Manager (DTM)." You can download this manual free of charge
from our website www.pepperl-fuchs.com in the product selector under
Products > Software > PACTware > Product list > PACTware 4.1 > Documents.
The following section describes only the device-specific settings for the
HART multiplexer master KFD2-HMM-16.
To Next Page
Loading...