Pepwave MAX and Surf User Manual
http://www.pepwave.com 121 Copyright @ 2016 Pepwave
Event Logging
This setting specifies whether or not to log matched firewall events. The logged messages
are shown on the page Status>Event Log. A sample message is as follows:
Aug 13 23:47:44 Denied CONN=Ethernet WAN SRC=20.3.2.1
DST=192.168.1.20 LEN=48 PROTO=TCP SPT=2260 DPT=80
• CONN: The connection where the log entry refers to
• SRC: Source IP address
• DST: Destination IP address
• LEN: Packet length
• PROTO: Protocol
• SPT: Source port
• DPT: Destination port
Click Save to store your changes. To create an additional firewall rule, click Add Rule
and repeat the above steps.
To change a rule’s priority, simply drag and drop the rule:
• Hold the left mouse button on the rule.
• Move it to the desired position.
• Drop it by releasing the mouse button.
Tip
If the default inbound rule is set to Allow for NAT-enabled WANs, no inbound Allow firewall rules will be required
for inbound port forwarding and inbound NAT mapping rules. However, if the default inbound rule is set as Deny,
a corresponding Allow firewall rule will be required.
To Next Page
Loading...
Need help?
General
