Some of these following symbols may be used on this tool. Please study them and learn their meaning. Proper interpretation of
these symbols will allow you to operate the tool better and safer.
Symbol Name Designation / Explanation
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watts Power
∿
Alternating current Type of current
Direct current Type of characteristic of current
no No-load speed Rotational speed at no load
Class II construction Double insulated construction
.../min Per minute Revolutions, strokes, surface speed
orbits, etc., per minute
Wear safety goggles
WARNING: The operation of any
power tool can result in foreign objects being
thrown into your eyes, which can result in
severe eye damage. Before beginning power
tool operation, always wear safety goggles or
safety glasses with side shields and a
full-face shield when needed. We
recommend a Wide Vision Safety Mask for
use over eyeglasses or standard safety
glasses with side shields. Always use eye
protection which is marked to comply with
ANSI Z87.1.
Be careful of your hand.
DANGER KEEP HANDS AWAY FROM
BLADE
WARNING: To ensure safety and reliability, all repairs should be performed by a qualified service technician.
SAFETY SYMBOLS
_ 3 _
To Next Page
Loading...
Need help?
General