PerkinElmer Lambda 365 Installation Instructions

09931286E
11
10. Connect the accessory interface cable of the Peltier Controller to the interface connector of the 6-
Position Peltier Controlled Cell Changer.
Figure 13 Connecting the accessory interface cable of the Peltier Controller
11. Connect the coolant inlet/outlet and N
2
gas tube between the Peltier Controller and the
6-Position Peltier Controlled Cell Changer.
Figure 14 Connecting the coolant inlet/outlet and N
2
gas fitting
NOTE:
N
2
gas is not always required. If no gas is applied, user does not have to connect N
2
gas tube.
12. Open the lid of Interface slot for Temperature Probe by hand.
Figure 15 Opening the lid of Interface slot

PerkinElmer Lambda 365 Specifications

General

Brand	PerkinElmer
Model	Lambda 365
Category	Laboratory Equipment
Language	English