09931286E
21
8. Select Connection Check, then Method Setup will be activated. Select Method Setup.
NOTE:
Check the communication between Computer and Peltier Controller referring to the chapter
Setting USB to RS-232 Cable (p15) if the Method Setup is not activated.
9. The Peltier window will be shown. Select the Multi Cell Peltier tab and set parameters according
to the experiment conditions.
▶Multi-Cell holder
a. Available Cells
Indicate cells that are available for measurement. In the case of 6-Position Peltier Controlled Cell
Changer, six cells are available.
To Next Page
Loading...
