L1050069A
12
Re-instating the configuration file
Should you ever need to revert to the standard instrument configuration file, follow the steps
described below.
1. Browse to C:\pel_apps\bin\
The instrument configuration file is named C*****.cfg, where ***** is the five-digit
serial number of the instrument.
The spectrometer serial number is located on its base casting, in the sample
compartment, under the sample accessory baseplate.
2. Copy the appropriate C*****.cfg file, and save it as, for example C*****.extdet
NOTE: Make sure that you save this backup of the external detector configuration file.
3. Rename C*****.intdet (the backup of your original internal detector configuration file)
as C*****.cfg
NOTE: If a backup of the original configuration file was not made, uninstall the instrument
and then re-install it using the configuration disk supplied with the instrument.
Selecting the Third-party Detector using Spectrum or
Spectrum Express Software
Before you begin, make sure that:
• The required version of Spectrum or Spectrum Express software is installed and
configured. See
Configuring Spectrum or Spectrum Express Software to Use a Third-
party External Detector
on page 7.
• The instrument is powered and has been allowed to stabilize.
To select the external detector in Spectrum software:
1. Start Spectrum, select the Setup menu and then click Instrument.
The Scan and Instrument Setup dialog is displayed, showing the Instrument tab.
2. Select the Beam tab.
To Next Page
Loading...
Need help?
General
