Safety Section
i05898546
Safety Messages
There may be several specific warning signs on an
engine. The exact location of the hazards and the
description of the hazards are reviewed in this
section. Become familiar with all warning signs.
Ensure that all of the warning signs are legible. Clean
the warning signs or replace the warning signs if the
words cannot be read or if the pictures are not visible.
When the warning signs are cleaned, use a cloth,
water, and soap. Do not use solvent, gasoline, or
other harsh chemicals to clean the warning signs.
Solvents, gasoline, or harsh chemicals could loosen
the adhesive that secures the warning signs. The
warning signs that are loosened could drop off the
engine.
Replace any damaged warning signs or missing
warning signs. If a warning sign is attached to a part
of the engine that is replaced, install a new warning
sign on the replacement part. Perkins dealers or
Perkins distributors can provide new warning signs.
Do not work on the engine and do not operate the
engine unless the instructions and warnings in the
Operation and Maintenance Manual are understood.
Correct care is your responsibility. Failure to follow
the instructions or failure to heed the warnings could
result in injury or in death.
(1) Universal Warning
Do not operate or work on this equipment unless
you have read and understand the instructions
and warnings in the Operation and Maintenance
Manuals. Failure to follow the instructions or heed
the warnings could result in serious injury or
death.
Illustration 1 g01154807
Typical example
The Universal Warning label (1) will be located on the
valve mechanism cover. Refer to illustration 2 .
Note: The location of this label will depend on the
application of the engine.
Illustration 2 g03715977
Typical example of a four cylinder engine
(2) Ether
Do not use aerosol types of starting aids such as
ether. Such use could result in an explosion and
personal injury.
SEBU7833
5
Safety Section
Safety Messages
To Next Page
Loading...
