perma-tec GmbH & Co. KG
The Expert in Lubrication Solutions
5 STARTING AND OPERATING 10
5.1 Preparation 10
5.2 Before operation 10
5.3 Initial operation 10
5.4 During operation 11
6 CHANGING THE LC UNIT 12
6.1 General note 12
6.2 How to change the LC unit 12
7 DRIVE UNIT SETTINGS 13
7.1 Function display 13
7.2 Circuit board settings 13
7.2.1 Setting discharge amount 14
7.2.2 Setting volume of LC unit 14
7.3 Table of discharge 14
7.3.1 Examples for determining proper dip switch settings to achieve
optimal lubrication 15
7.3.2 Changing the discharge volume after the perma STAR CONTROL TIME
has been in operation/reset function 17
8 TROUBLE SHOOTING 18
9 DISPOSAL 19
10 ACCESSORIES FOR perma STAR CONTROL IMPULSE 19
10.1 Accessories 19
10.2 Replacement parts 19
11 SERVICE 19
12 SUGGESTION FOR PLC CONNECTION 20
12.1 Suggestion for PLC connection with one output signal 20
12.2 Suggestion for PLC connection with two output signals 21
12.3 Suggestion for PLC connection with three output signals 22
EC Declaration of Conformity
To Next Page
Loading...
