perma-tec GmbH & Co. KG
- 2 -
The Expert in Lubrication Solutions
1.2 Delivery
♦ perma STAR CONTROL TIME can be ordered and delivered according to custo-
mer specications in regards to type of grease and oil, size / content of LC unit.
♦ Upon delivery, make sure to check if the delivered goods correspond to your
order. perma-tec GmbH & Co. KG will not accept liability for subsequent claims
of any shortcomings.
♦ Please immediately forward any claim
▪ of noticeable transport damage: directly to the forwarder
▪ of noticeable faults, shortcomings or defects: directly to your perma distributor.
1.3 Lubricator perma STAR CONTROL TIME
1.3.1 Markings
♦ The lubricator perma STAR CONTROL TIME is clearly marked with a label on
the drive system and a label on the LC unit.
♦ CE Mark on the drive unit
♦ Manufacturer:
perma-tec GmbH & Co. KG
Hammelburger Straße 21
97717 Euerdorf, Germany
Tel: +49 (0) 9704 609-0 E-mail: info@perma-tec.com
Fax: +49 (0) 9704 609-50 Homepage: www.perma-tec.com
1.3.2 Intended Usage
♦ The lubricator perma STAR CONTROL TIME
▪ supplies all lubrication points with oil and grease to a large extent continu-
ously, precisely and temperature independent up to a pressure build-up of
max 5 bar / 75 psi; can be turned off and on via the machine (machine
controlled).
▪ can be used for all lubrication points of sliding- and roller bearings, drive-
and transport chains, sliding guideways, open gears and seals.
▪ is intended for use on machinery and equipment where lubrication is only
to take place when the machine is running, and where a status report to the
machine is desired.
▪ is only to be used for the ordered purpose and purposes conrmed by
perma-tec.
To Next Page
Loading...
