M1
Handling
Joystick error
Joystick error at startup
Figure 161. Joystick moved from the central position.
Do not move the joystick before, during or immediately after the
control system is switched on. If the joystick is moved from the
central position, a joystick error may be generated.
Joystick error LED panel
Figure 162. The LEDs on the battery voltage indicator.
While the control system checks if an error has occurred, the LEDs
on the battery voltage indicator will wander backward and forward.
If the control system detects an error in the wheelchair electronics,
the battery voltage indicator LEDs will flash rapidly. To enable the
wheelchair to be driven again, make sure the joystick is in the central
position. Then switch the wheelchair off and on again. If this does
not work and the LEDs still flash rapidly, contact your service
provider.
192
To Next Page
