Warnings and Safety Regulations
28
Connect the batteries:
1 Attach one end of a jumper cable to the positive (+) terminal of the discharged
(dead) battery. This will have a large red + or P on the battery case, post, or
clamp.
2 Attach the other end of the same cable to the positive (+) terminal of the good
(booster) battery.
3 Attach the remaining jumper cable FIRST to the negative (-) terminal (black or
N) of the good battery.
4 Attach the other end of the negative cable to a bare metal part not bolted to the
engine block.
IMPORTANT: Always connect positive (+) to positive (+) and negative (-) to
negative (-).
5 If either vehicle is equipped with battery disconnects, ensure that they are in the
"ON" position.
6 Start the vehicle that has the good battery first. Let it run for 5 minutes.
7 Start the vehicle that has the discharged (dead) battery. If the engine fails to
start, do not continue to crank the starter and contact the nearest authorized
dealer
To Next Page
Loading...
