9.06 Setting the zigzag stitch and the stitch position
● Set the zigzag stitch width by turning the
zigzag lever 1.
● To vary the adjustment press catch 2
against zigzag lever 1.
● The setting can be read from scale 3.
● Set the stitch position by turning stitch
position lever 4.
L = stitch position on left
M = stitch position in the middle
R = stitch position on the right
Fig. 9 - 09
2
1
9.07 Adjusting the stitch length
● Adjust the stitch length by turning the
feed regulator wheel 1.
● The setting can be read on scale 2.
M
L
R
4
3
2
1
Fig. 9 - 08
To Next Page
Loading...
