PGO BR-500 - Page 287

B. SERVICE AIR CLEANER ELEMENT
1. Service air cleaner every 3,000 kilometers (approximately 6 months).
ATTENTION: You must service it more often when used under dusty conditions
, even inspect it
every time after usage!
2. Procedure
 Loosen the 9 fixing screws.
 Remove cleaner cover.
 Remove air cleaner element.
 Clean the sponge by compressed air.
 Check the blow-by and condensate exhaust pipe and empty it, if full.
3. Cleaning
 The element of BR-500 is sponge type, that means you can maintain it to multiple
usage.
a. Wash the sponge with water and shampoo.
b. Dry up by small compressed air jets and a clean cloth.
c. Soak with 50% fuel and oil SELENIA AIR FILTER OIL mixture.
d. Let the filtering element drip and press it with your hands without
squeezing.
e. Replace the filtering element.
Caution: Never let the engine run without air filter. This would cause an
excessive wear of cylinder and piston and would damage the
injector.
4. Model photo
Outside cover Sponge element
P.3-7
PGO BR-500 ENGINE
Maintenance