PGO BR-500 - Pre-Drive Inspection Checklist

B. Pre-Drive Inspection
Perform this pre-drive inspection everyday before driving vehicle. If not
Performed, serious damage to the vehicle or personal injury may result.
Always follow rules for safe operation and wear a helmet.
a. Check for Engine Oil Level. Check for leaks, add oil if required.
b. Check for Fuel Level. Add fuel as necessary and do not overfill. Check
for leak.
c. Check for engine coolant, Add coolant as necessary and check for
leaks.
d. Check for Brakes. Depress the rear brake pedal several time, then
check for proper brake pedal free-play. Make sure there is no brake
fluid leakage. Adjust if necessary.
e. Check Tires. Check tires condition and pressure.
f. Check Throttle. Check for smooth operation. Assure throttle “snaps”
back to idle.
g. Check Parking Button. Perform button test. Repair as necessary.
h. Check all Nuts, Bolts, and fasteners. Check wheels to see that all axle nuts and lug nuts are
tightened properly. Check and tighten as necessary all other fasteners to specified condition.
i. Check Roll Cage Bar. Ensure all protective roll cage bars are in place before operating the
Kart.
j. Check Brake Light. Check for proper operation.
k. Check Wheels. Check for tightness of wheel nuts and axle nuts; check that axle nuts are
secured by cotter pins.
l. Check Steering. Check for free operation for any unusual looseness in any area.
C. Component Location
1. Vehicle Identification Number (VIN) is located (stamped)at the
right side of frame.
NOTE:
The first 9 digitals are type, the last 8 digitals are production
serial numbers.
Your dealer need this number for ordering the parts, Please
write down the engine no. for their reference.
2.Engine No. is located (stamped)on the rear side of the left
crankcase.
NOTE:
The upper row is model type, the lower row is production
serial numbers.
Your dealer need this number for ordering the parts, please
write down the engine no. for their reference.
P.2-8
PGO BR-500 ENGINE