PGO BR-500 - Page 37

- Turn the central pulley nut to
horizontally align the holes and
install the specific tool.
N.B.:
Check that the stop
wrench tool is easily inserted
into the pulley and in the
engine crankcase.
Specific equipment and
tools:
Driving pulley stop
wrench 020474Y004
- Insert the retain band on the
rear side, so that the groove is
fully abutted.
- Finally install the tool by
siding the nuts by hand and
ensuring the tool is resting
flatly.
- Tighten the driving pulley
fastening nut at the prescribed
torque
- Remove the specific tool.
Tightening torque:
Driven pulley shaft nut:
160 ~175 Nm
PGO BR-500 ENGINE
P.10-18
Automatic Transmission