- Drain the rear hub oil through
the oil drainage cap located
under the Engine.
- Drain the rear hub oil through
the oil drainage cap located
under the Engine.
- Remove the 7 fastening
screws.
Remove the hub cover and the
relevant gasket
PGO BR-500 ENGINE
- Remove the lay shaft.
- Remove the wheel axle with
gear.
- Check all bearings (wear,
clearance and noise).
In case of anomalies, proceed
as follows.
To remove the wheel axle
bearing on the engine
crankcase, use the following
parts.
Specific equipment and
tools:
15-mm pliers: 001467Y34
or 001467Y014
Bell: 001467Y031
To remove the lay shaft bearing
on the engine crankcase, use
the special removing tool.
Specific equipment and
tools:
20-mm pliers:
001467Y006
Bell: 001467Y035
P.10-23
Final Reduction
To Next Page
