Pharos Smart Navigator - Using Features in Smart Navigator; Creating a Route

32
6.0 Using Features in Smart Navigator
6.1 Creating a Route
Note:
GPS needs to be enabled in
Smar
t Navigator
before navigation can
begin. Refer to Section 8.0 GPS Receiver Setup and Configuration.
To create a Route, you need to have both an
Origin
and a
Destination selected. These PORs (Points of Reference) are
defined below:
• The Origin is your starting point. If the GPS has a lock
and the GPS position indicator (red arrow) is displayed on
a paved road, the center of the screen will represent your
Route Origin.
You can also select any location on the map as the Origin by
double-tapping the screen and choosing Origin.
• The Destination is your ending point. You can search for
your Destination by using any of the following methods
from the Go screen: Address, Point of Interest, My
Places, or Home (Home is a pre-designated location and
cannot be selected unless a location has been previously
saved as Home).
Again, you can also use any location on the map as the
Destination, just by double-tapping the screen and choosing
Destination.
Note: For information regarding Multi-Stop Routing, refer to Section 6.2
Adding Multi-Stops to a Route.
Note:
If you do not have a GPS lock, we suggest that you locate the
Origin first, and then the Destination.