ON-LINE RACK PH 9360 - PH 9301 .
When the input voltage is beyond the
acceptable range or power failure,
UPS will backup power from battery and alarm
will beep every 4 seconds.
When input voltage is within acceptable
range and bypass is enabled, turn off the
UPS and it will enter Bypass mode. Alarm
beeps every two
minutes.
When UPS is in AC mode or CVCF mode,
press “Test” key for more than 0.5s. Then
the UPS will beep once and start “Battery
Test”. The line between I/P and inverter
icons will blink to remind users. This
operation
is used to check the battery status.
When UPS has fault happened, it will display
fault messages in LCD
panel.
.
To Next Page
Loading...
