Mounting the viewfinder mask
The image area of the Hasselblad camera body is ap-
proximately 6 cm x 6 cm, whereas the image area of
the P back is a lttle bit smaller. Therefore, it is neces-
sary to use the P back viewfinder mask. Remove the
protection tape from the mask and mount it beneath
the original focusing screen.
The viewfinder
mask is positioned
in the bracket
that holds the
focusing screen.
Please refer to
the Hasselblad
camera manual
instructions before
the focus screen
is removed.
After the Phase
One viewfinder
mask is
positioned in the
bracket, place
the Hasselblad
focusing screen
on top of the
mask and slide
the viewfinder top
back into place.