Hasselblad 555 ELD
When using the Phase One P back with a Hasselblad
555 ELD, the shutter release on the front of the
Hasselblad must be in the “Digital” position.
If, of any reason, you have to use
the shutter release in “Film” posi-
tion (hardware defect on the DIG
button etc.) You must make sure
that the Shutter latency is set to
”Short latency” in the P back or in
the Capture One application.
Shutter latency settings
On the Hasselblad 555 ELD the P back can be used
with both Long and short latency.
All other Hasselblad cameras requires you to set the P
back in Short latency.
Default your P back is set to Short latency, which
means that the P back will respond fast on triggering
on the cost of battery time.
To save battery time you can set the P back to Long
latency, and thereby gain extra valuable time before
the battery runs dry. This on the cost of response time.
To learn how to setup latency please consult the Menu
mode section
No Motor cable on 555 ELD
A motor cable is not required when using the camera
on an Hasselblad 555 ELD body.
To Next Page
Loading...
Need help?
General
